Owner manual

9400 HighLine | Parameter setting & configuration
TAs for interconnection via electrical shaft
TA "Synchronism with mark synchronisation" | "Synchronism" mode"
344 Firmware 1.37 - 09/2006 L
12.3.5 "Synchronism" mode"
In the "Synchronism" (C03006 = "0") operating mode the drive follows the master value of
the electrical shaft if the clutch is engaged.
[12-26] "Synchronism" mode (schematic diagram)
Functions in the "Synchronism" operating mode
 Master value processing
 Mark synchronisation (master value)
 Virtual clutch
 Master value adjustment
 Setpoint conditioning
 Mark synchronisation (setpoint)
O Tip!
A description of the different functions for conditioning the master value can be
found in the following subchapters.
M
v
Slave
Real master/
Virtual master
C03006 = 0
v
t
Dj
302 4
Dj Dj
15
TP TP