Owner manual

9400 HighLine | Parameter setting & configuration
Technology applications (TAs)
Commissioning using the »Engineer«
236 Firmware 1.37 - 09/2006 L
10.2.1 Parameterise application
In the »Engineer« all required settings for the technology application can be made via the
Application parameter tab which contains several levels of parameter dialogs.
r The top level Overview includes all parameters required to carry out a short setup.
– The left half of all technology applications is nearly identical and serves to set mains,
motor and gearboxes and the basic functions supported by the technology
application.
– The right half, however, depends on the technology application selected.
[10-2] Example: Parameter setting dialog in the »Engineer« for a technology application
r If you click on one of the pictographs marked with the symbol , you get one level
deeper in the corresponding parameter dialog.
r This parameter dialog can also have further subordinate parameter dialogs, depending
on the complexity.
O Tip!
The online documentation for the »Engineer« contains detailed information on
how to work in the Application parameter tab.
n Mains voltage
o Basic functions
p Motor/feedback system
q Gearbox
r Technology application