Owner manual

1.6 EN - 01/2011 L 5
Control technology | IPC Backup & Restore
About this documentation
Further technical documentation on Lenze components
More information on Lenze components that can be used together with "PC-based
automation" can be found in the following documentation:
Target group
The documentation is designed for qualified skilled personnel in accordance with IEC 364.
Mounting & wiring Legend:
 MA 8400 StateLine/HighLine  Printed documentation
 MA 9400 StateLine/HighLine  Online help/PDF
 MA EPM-Txxx (I/O system IP20) Abbreviations used:
 MA EPM-Sxxx (I/O system 1000) SHB System Manual
 MA 8200 vector BA Operating Instructions
 Wiring according to EMC - 8200 vector MA Mounting Instructions
 MA ECSxS/P/M/A axis modules SW Software Manual
 MA ECSxE power supply modules KHB Communication Manual
for built-in units:
• built-in unit
• push-through technique
• cold-plate technique
 MA MC-CAN2 communication card
 MA MC-ETC communication card
 MA MC-ETH communication card
 MA MC-PBM communication card
 MA MC-PBS communication card
 MA MC-MPI communication card
 MAs for communication modules
Parameter setting, configuring, commissioning
 SW 8400 StateLine/HighLine frequency inverter
 SW 9400 StateLine/HighLine/PLC drive controller
 9400 HighLine commissioning guide
 SHB I/O system IP20 (EPM-Txxx)
 SHB I/O system 1000 (EPM-Sxxx)
 SHB 8200 vector
 BA ECSxS axis module "Speed and Torque"
 BA ECSxP axis module "Posi & Shaft"
 BA ECSxM axis module "Motion"
 BA ECSxA axis module "Application"
 BA ECSxE power supply module
 KHBs for communication modules