Owner manual

Control technology | IPC Backup & Restore
About this documentation
4 L 1.6 EN - 01/2011
1 About this documentation
This documentation contains information on the parameterisation and configuration of
industrial PCs. The "PC-based automation" supports industrial PCs of the following device
series:
 EL 1800 - EL 9800,
 CS 5800 - CS 9800,
 CPC 2800.
The industrial PCs are available with the following software equipment:
 Industrial PC as component, on request, with operating system, without additional
software
 Industrial PC as visualisation system
 Industrial PC as control and visualisation system
Depending on the software equipment acquired, some chapters of this Manual may be
irrelevant to you.
This Manual is part of the "PC-based Automation" manual collection which consists of the
following documentation:
Documentation Subject
System manuals
PC-based Automation
• Control technology - system structure & configuration
• Visualisation - system structure & components
Communication manuals
PC-based Automation
• CANopen control technology
• EtherCAT control technology
• PROFIBUS control technology
(Software) manual
PC-based Automation
• Industrial PC - Parameterisation & Configuration
Operating Instructions
Embedded Line Panel PC
• EL x800 - Panel PC with TFT display
Operating Instructions
Command Station
• CS x800 - Stand-alone operator terminal
Operating Instructions
Control Cabinet PC
• CPC 2800 - Control cabinet PC
Operating Instructions
HMI EL 100
• EL 1xx - HMI with Windows
® CE
Further software manuals • Global Drive Control (GDC)
• IPC as gateway - Parameterisation & Configuration
• »Engineer«
• »PLC Designer« / »PLC Designer - SoftMotion« / »PLC Designer - CANopen
for runtime systems«
• »VisiWinNET® Smart«