Owner manual

1.6 EN - 01/2011 L 33
Control technology | IPC Backup & Restore
Operation
Backup & Restore with a USB stick
CAB: Lenze software
CESYS: Windows® CE operating system, boot loader
After the write process of the »IPC Backup & Restore« has been completed, the data
required for a software update are available on the USB stick.
 Then execute a software update by connecting the USB stick to the industrial PC.
Executing a software update at the industrial PC
 How to execute a software update at the industrial PC:
1. Connect the USB stick described before in »IPC Backup & Restore« to the USB
terminal of the industrial PC.
2. Restart the industrial PC.
• With the previously activated setting Show selection dialog carry out the
instructions given in the industrial PC manual. In the case of industrial PCs with
a display, the dialog window shows a dialog window with the software updates
available on the USB stick.
 Note!
If software update version 1.5 is used, manual steps are required which are
described in the following documentation:
• "PC-based Automation": Industrial PC - parameter setting & configuration
Chapter "IPC Backup & Restore", section "Software update procedure".
 More information on the use of the »IPC Backup & Restore« at the industrial PC can
be found in the following documentation:
• "PC-based Automation": Industrial PC - parameter setting & configuration
 chapter "IPC Backup & Restore"