User Manual

12 Visualisation with »VisiWinNET®«
12.3 Using the visualisation to access data of the control/parameters
99
Lenze · Controller | Parameter setting & programming · Reference Manual · DMS 1.5 EN · 04/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
12.3 Using the visualisation to access data of the control/parameters
Variables of the PLC (Logic/Motion) can be accessed with the "LogicAndMotionV3" direct driver.
Here, the »VisiWinNET®« Runtime may be on a local controller or on an external controller.
 Note!
We recommend the use of the "LogicAndMotionV3" direct driver for easy
commissioning.
Use the Direct driver "LogicAndMotionV3" (local visualisation)
( 101)
There is no OPC server available for PROFIBUS and PROFINET.
Controller c300/p300:
• The OPC communication for »VisiWinNET« is exclusively available for Controller p300
without
PLC.
• Otherwise, only the Lenze "Logic&Motion" direct driver can be used for the data
exchange between »VisiWinNET« and PLC.
Use the "LogicAndMotionV3" direct driver to
access the following parameters:
• PLC (Logic/Motion) data
• Lenze recommend to use the
"LogicAndMotionV3" direct driver.
• Alternatively, you can access the following
data via the OPC tunnel:
• DataManager OPC server
 Controller parameters.
• CAN/EtherCAT OPC server
 Field device parameters (CAN/
EtherCAT).
• SoftPLC OPC server
 Variables of PLC (Logic/Motion):
Communication type / description Access to ...
Direct driver "LogicAndMotionV3"
(Recommended connection type!)
Use the Direct driver "LogicAndMotionV3" (local
visualisation) ( 101)
PLC (Logic/Motion) data
• DataManager OPC tunnel
• DataManager Remote OPC tunnel (remote access)
Parameters of the Controller