User Guide

IB-PR355-WM-E-123003
RADIO OPERATION
AM broadcast band:
1. Slide the BAND switch to AM position.
2. Rotate the VOLUME control downwards past click, the set will turn on. To turn
the set off, rotate the VOLUME control upwards until past click.
3. Tune the set to the desired station by rotating the TUNING control.
4. Best reception can be received by carefully tuning the set and rotating the set
slightly.
2
INSERT 3 SIZE AA
ALKALINE BATTERIES
BACK OF SET
PUSH AND PULL THE
BATTERY DOOR OUT
FM broadcast band:
1. Slide the BAND switch to FM position.
2. Follow above points 2 and 3.
3. Your set is equipped with a TELESCOPING FM ANTENNA. For best results,
fully extend the TELESCOPING FM ANTENNA.
BATTERY INSTALLATION
1. Lift and pull the BATTERY DOOR out.
2. Insert 3 size AA alkaline batteries.
3. We recommend alkaline batteries for longer life.
4. Close the BATTERY DOOR.

Do not mix old and new batteries.

Do not mix alkaline, standard (Carbon-Zinc) or rechargeable (Nickel-
Cadmium) batteries.
REPLACEMENT OF BATTERIES MUST BE DONE BY ADULT
BATTERY REPLACEMENT
Exhausted batteries may leak and damage the set, or cause weak or distorted
reception. Replace batteries when required. When the set is not to be used for an
extended period, remove the batteries from the radio.
ANTENNAS
Your new radio is equipped with a built-in ferrite rod antenna for use on the AM BAND,
plus a TELESCOPING ANTENNA for FM reception. Since all transistor radios are
slightly directional, it is desirable to rotate the radio to obtain the best reception.