Download

8
POLE SAW INFORMATION
OPERATION
Fig.2
1. Insert/remove the battery pack (See Fig.2)
•Always release the On/Off switch (2) before insertion or removal of the battery pack.
•To remove the battery pack, withdraw it from the tool while pulling the Battery Release
Button (3) down.
•To insert the battery pack, slide the battery along the handle groove and insert in the full
position, until the Battery Release Button (3) “clicks” and moves back to the normal
position again.
2. How to switch on or switch off? (See Fig.2)
To start the machine, press the lock-off button (1) and then the On/Off switch (2) at the
same time. When the machine is running, the lock-off button (1) can be released again.
To switch off the machine, release the On/Off switch (2). The machine will stop.
POLE SAW ASSEMBLY
WARNING: Cutting edges on chain are sharp. Use protective gloves when holding
the pole chain.
1. Remove battery pack from pole saw.
2. Connect the upper pole and the lower pole together.
IMPORTANT: When inserted, the arrow 1 would have to target the arrow 2, and must
be inserted fully. (See Fig.3)