Download

11
of operation. Allow chain to cool down. Follow steps below to check saw chain tension.)
1. Remove battery pack from pole saw.
2. Place pole saw on a firm surface to check chain tension.
3. Pull chain with light force 3mm (1/8") away from bottom of guide bar and release
(See Fig 8). If the chain lightly snaps back into place, the tension is correct, a slight sag
of 1 - 1.5mm (1/16" or less) between chain and bottom of guide bar is acceptable.
Fig.8
Saw Chain Tension Adjustment
1. Loosen guide bar screw before adjusting chain. (See Fig 9)
Fig.9
2. Turn adjusting screw on front of power head clockwise until excessive slack is
removed from the chain.(See Fig 10 )
Fig.10