User Guide

4
Updating the firmware
Connect the Lenovo Explorer headset to your computer and pair the controller with your
computer. If the latest controller firmware is available, the firmware will be downloaded to
the controller and installed automatically the next time you turn on the controller. During the
installation process, controller LEDs are illuminated and keep blinking in a circular motion
for 1-2 minutes. After the firmware update is completed, the controller will restart and
reconnected to the headset.
Motion controller vibrations and constellation LEDs
behavior
The motion controller vibrations and constellation LEDs indicate the status of the motion
controller.
Motion controller
status
Motion controller
vibrations
Constellation LEDs behavior
Turning on or paired
Once
On
Turning off
Twice
Off
Sleep
─
Blink every three seconds
Pairing
─
Pulse slowly
Paring failed or time-
out
Three times
Blink three times
Disconnected from
computer
Once
Blink once
Battery power low
Twice
• Blink twice if the battery power is
low.
• Blink three times if the battery
power is critically low.
Firmware update
─
Blink in a circular pattern
Notes:
• The motion controller enters sleep mode if it is idle for over 30 seconds. The motion
controller automatically wakes up when it detects motion.
• The motion controller turns off automatically if it is idle for over three minutes.
• You can check the battery status by the battery-status icon on the motion controller in
mixed reality. The icon is red when the battery power is low.