Specifications
Table Of Contents
- Contents
- About this manual
- Safety information
- Important service information
- General checkout
- Related service information
- Lenovo 1051
- Specifications
- FRU replacement notices
- Removing and replacing an FRU
- 1010 Rear cover
- 1020 Right speaker
- 1030 Vibrator motor
- 1040 Sub board
- 1050 LCD FPC
- 1060 Main FPC
- 1070 HDMI FPC
- 1080 Hall sensor FPC
- 1090 Main board
- 1100 Left speaker
- 1110 Rear camera
- 1120 USB and volume key FPC
- 1130 Volume key
- 1140 LTE main antenna (LTE version) or WIFI2 antenna (WiFi version)
- 1150 LTE MINO/GPS/WIFI1 antenna (LTE version) or GPS/ WIFI1 antenna (WiFi version)
- 1160 WIFI2 antenna (LTE version)
- 1170 Battery pack
- 1180 Power key
- Locations
- Parts list
- Notices
Lenovo 1051 Hardware Maintenance Manual
34
1030 Vibrator motor
For access, remove the following FRU:
• “1010 Rear cover” on page 28
1. Disconnect the power supply to the tablet by detaching the battery FPC from
its connector on the main board using a pair of tweezers.
Figure 3-1. Disconnecting the power supply of the tablet
2. Desolder the wires of the vibrator motor from the sub board at the position
shown in the figure below.
Figure 3-2. Position for desoldering the wires of the vibrator motor