FCC ID: O57SE551F Lenovo Smart Video Doorbell Setup Guide Document Version: 1.
Table of Contents Chapter 1 Introduction ............................................................................................................. 1 Package Contents .............................................................................................................. 1 Physical Details .................................................................................................................. 3 Chapter 2 Setup ...............................................................................
Chapter 1 Introduction 1 This chapter provides information about the features, components and capabilities of Lenovo Smart Video Doorbell. Package Contents The following items should be included: If any of these items are damaged or missing, please contact your dealer immediately. 1. Lenovo Smart Video Doorbell x 1 2. Screw/Anchor x 2 3. Leveler x 1 4.
5. Always-on Bracket x 1 6.
Physical Details Lenovo Smart Video Doorbell supports both analog and digital chimes within 16-24 AC voltage range. The operating temperatures of Lenovo Smart Video Doorbell with Alwayson bracket are –4°F to 104°F (–20°C to 40°C) on day mode and –4°F to 95°F (–20°C to 35°C) on night mode. Note: The internal battery of Lenovo Smart Video Doorbell will not be charged when the temperature is < 32°F (0°C) and > 122°F (50°C) or discharge when internal temperature is < -4°F (-20°C) and >138°F (60°C).
Rear Panel Reset Button When pressed and held over 10 seconds, the LED will be solid amber, which means Lenovo Smart Video Doorbell will be reset to default settings. On/Off Switch Use this switch to power on/off Lenovo Smart Video Doorbell. Micro USB Connector This connector is used for charging the internal battery in case Lenovo Smart Video Doorbell does not have enough power for setting up and connecting to the Wireless network before mounting to the Always-on bracket.
Chapter 2 Setup This Chapter provides details on how to install and configure Lenovo Smart Video Doorbell. 2 Installation 1. Power-Up and Check LED Turn on the On/Off switch on the rear side of Lenovo Smart Video Doorbell and wait for 20 seconds until the LED turns to slow green blinking. Note: The internal battery supports about 40 minutes of operation.
4.2. Power on Lenovo Smart Video Doorbell. The green light should be blinking slowly. 4.3. Tap the “ ” icon in the upper right-hand corner. Choose Camera > Add Device > Smart Video Doorbell. 4.4. Follow the instructions in the app. 4.5. If the setup fails, Press and hold the reset button for over 10 seconds, until the LED is solid amber. And repeat the setup process. Note: Lenovo Smart Video Doorbell only supports 2.4GHz Wireless networks. It does not support 5GHz or 2.
Chapter 3 Hardware Installation This chapter covers the most likely problems and their solutions. 3 Overview Note: Ensure Lenovo Smart Video Doorbell is configured and connected with the Wireless router before permanently mounting. Note: Lenovo Smart Video Doorbell must be attached with indoor chimer and transformer used for power supply loop. (While mounting Always-on bracket, it must use 16-24V transformer to power up Lenovo Smart Video Doorbell) 1. 2.
3. Unscrew the legacy doorbell button to locate two power wires. (Recommended installation height is between 47-60 inches.) 4. Take out Always-on bracket and EVA foam from the package. 5. Connect the power wires from the legacy doorbell button through the EVA foam to the screw terminals of Always-on bracket. (The power wires should use 20AWG) 6. Make sure the power wires are all hidden behind the wall.
7. Secure Always-on bracket with screws. Note: Install the anchors if necessary. The provided lever can be used for measuring angles to prevent inclination. 8. Attach Lenovo Smart Video Doorbell to the mounting bracket. Make sure Lenovo Smart Video Doorbell is firmly attached and working properly. Caution: To avoid damaging the pogo pins of Always-on bracket, the bracket should lay flat against the wall and Lenovo Smart Doorbell is firmly attached to the bracket.
Power Kit Installation The Power Kit included with Lenovo Smart Video Doorbell is a small device, which supports Lenovo Smart Video Doorbell with any kinds of analog and digital chimes by going between the doorbell transformers and chime wiring. Note: Before removing or attaching wires to your legacy doorbell, be sure that the power is turned off at the breaker box. Consult a licensed electrician if needed. 1. Turn off the circuit breaker for the indoor chimer. 2. Remove the cover from the indoor chimer. 3.
Always-on Bracket Specification LED LED x 1 (Green) Pogo Pin 2 x 4 (8 Pin) Power AC16-24V Dimensions (H x W x D) 5 x 1.69 x 0.5 inch (127.2mm*43mm*12.9mm) Always-on Bracket LED Activity & Behavior Activity Connected to Lenovo Smart Video Doorbell LED Color LED Intensity LED Behavior Description Blue Dim Solid After connected to Lenovo Smart Video Doorbell, LED color will turn to dim blue.
Appendix A Specifications A Lenovo Smart Video Doorbell Model Lenovo SE-551F Dimensions (H x W x D) 4.9 x 1.61 x 0.96 inch (124.52mm*41.06mm*24.42mm) Operating Temperature Always-on Bracket mode: -4℉ to 104℉ (-20℃ to 40℃, Day Mode) -4℉ to 95℉ (-20℃ to 35℃, Night Mode) Storage Temperature -4℉ to 113℉ (-20℃ to 45℃) Wireless 802.
https://support.lenovo.com Warranty Information Lenovo Limited Warranty notice This product is covered by the terms of the LLW, version L505-0010-02 08/2011. Read the LLW at http://www.lenovo.com/warranty/llw_02. You can read the LLW in several languages from this Web site. If you cannot view the LLW from the Web site, contact your local Lenovo office or reseller to obtain a printed version of the LLW.
Regulatory Approvals FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of FCC Rules. This limits designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Legal notices Lenovo and the Lenovo logo are trademarks of Lenovo in the United States, other countries, or both. Other company, product, or service names may be trademarks or service marks of others. LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant a General Services Administration “GSA” contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925. © Copyright Lenovo 2019.