User Guide
Table Of Contents
- Shipping and Packing List
- Optional Accessories
- Introduction
- Terminology
- Installation Considerations
- Overview
- Downloading Lennox Smart Technician App
- Installation
- Adding SAQM
- Management - Replace, Remove and Factory Reset
- Dimensions, Operating and Storage Specifications
- Thermostat Alert Codes for the Smart Air Quality Monitor
- Lennox Smart Air Quality Monitor Troubleshooting
- FCC Compliance Statement
5
Table 1. Terminology
Term
CO
2
CO
2
or carbon dioxide is an odorless, colorless,
non-ammable gas. Carbon dioxide is a by-product
of combustion, as well as a result of the metabolic
process in living organisms (for example, you remove
it from your body via the lungs in exhaled air).
BLE
BLE stands for Bluetooth Low Energy. BLE is a
variation of the Bluetooth wireless standard designed
for low power consumption.
Installation Considerations
If the desired installation location for the SAQM
is not within range of the thermostat, then a
Lennox Wireless Extender (22V26) can be used to
increase the effective range of the network.
Do
• Read this entire document, noting which
procedures pertain to your specic equipment
and system requirements.
• Conform to local and national building and
electrical codes and ordinances.
• Installed SAQM a minimum of
.
• Installed on a wall with a minimal distance six (6)
inches (154mm) from the S40 thermostat.
• Install in a common area for air sampling.
Do Not
• Install on voltages higher than 30VAC.
• Install in direct sunlight
• Install near discharge air vents.
• Install near replaces or other heat sources
• Install on exterior walls
• Install near windows or doors
• Install near kitchens
• Install in rarely used rooms or hallways
Overview
The device collects data on fine particles (PM
2.5
),
VOCs and CO
2
. For further details, see "Table 1.
Terminology" on page 4 for full descriptions.
The device then transmits this data through smart
devices network to the thermostat which analyzes
the data and displays it on the thermostat.