User Guide

22
Table 5. Lennox Smart Air Quality Monitor Alert Codes
Alert
ID
Source
device
Causing
Alert
Alert Code
Message
Priority
Condition
Troubleshooting Clear Condition
80002 Thermostat
XX:
Unresponsive
Wireless device
Fault
Service Soon
The smart device is connected to the
network but has failed to respond to
commands.
• Try cycling power to device. To
cycle power, remove device from
the wall and disconnect the R
terminal and then reconnect.
• If cycling power does not resolve
issue then:
» Remove device from the smart
devices network.
» Perform a factory reset of the
device. See "Factory Reset" on
page 17 for procedure.
» Attempt to add device back to
smart devices network.
If recycling power or factory
reset does not resolve issue
then replace the SAQM.
Automatically clears when
the system detects that the
issue no longer exists.
80003 Thermostat
Lost
communication
with wireless
device
Service Soon
• Try cycling power to the device.
To cycle power, remove device
from the wall and disconnect the R
terminal and then reconnect.
• If cycling power does not resolve
issue then:
» Remove device from the smart
devices network.
» Perform a factory reset of the
device. See "Factory Reset" on
page 17 for procedure.
» Attempt to add device back to
smart devices network.
If recycling power or factory
reset does not resolve issue
then replace the SAQM.
Automatically clears when
the system detects that the
issue no longer exists.