User Guide

16
Laura’s Room
Wireless Sensors
Add Sensor
Connected to System Name S40 0001
Cancel
If you wish to pair another sensor,
tap on the botton below.
If not tap Done to go back to
Equipment.
Sensor added to the network:
Add Sensor
Finish
Management - Replace, Remove and
Factory Reset
Use the Lennox Smart Technician App to
perform any of the following tasks.
To remove the SAQM from the Lennox S40
thermostat, use the Lennox Smart Technician
App.
IMPORTANT
It is recommended that any working smart
device that is taken out of service, should be
removed from the network and a factory reset
performed.

1. Navigate to Dealer Control Center >
Equipment Settings and select the SAQM
device to be removed.
2. Select either replace.
3. Press the pairing button on the new SAQM
to start the replacement procedure.
4. The app will search for the new SAQM.
If successfully found, then select the new
SAQM and then select the right arrow at the
bottom of the screen to continue.
5. A screen will appear indicating the SAQM is
being replaced.
6. If successful, a screen will appear indicating
replacement was successful.
7. Select Finish.