User Guide
Table Of Contents
- Shipping and Packing List
- Optional Accessories
- Introduction
- Terminology
- Installation Considerations
- Overview
- Downloading Lennox Smart Technician App
- Installation
- Adding SAQM
- Management - Replace, Remove and Factory Reset
- Dimensions, Operating and Storage Specifications
- Thermostat Alert Codes for the Smart Air Quality Monitor
- Lennox Smart Air Quality Monitor Troubleshooting
- FCC Compliance Statement
15
Wireless Sensors
Add Sensor
Connected to System Name S40 0001
Cancel
1. Press the pairing button on the
Sensor or Extender. The LED of the
sensor will start flashing.
2. The Technican App will search and
discover the sensor. Tap Next to
start discovering.
Where can I find the pairing
buttton on the sensor?
i
8. On the next screen, select the SAQM that
appears on the screen and then select the
right arrow at the bottom of the page.
Wireless Sensors
Add Sensor
Connected to System Name S40 0001
Cancel
Sensor Added to the Network
IAQ0002
Name the Sensor
9. The SAQM if successfully added will display
a screen conrming success. On this screen
the SAQM can also be renamed.
NOTE: Once the SAQM is added, the last four
digits of the smart device's BLE MAC ID
will be listed. Conrm ID with the BLE
MAC ID listed on back of smart device.
Wireless Sensors
Add Sensor
Connected to System Name S40 0001
Cancel
Sensor Added to the Network
0003
Name the Sensor
RENAME THE
SENSOR
LAST FOUR
DIGITS OF
DEVICE
BLE MAC ID
Lorem ipsum
NOTE: The smart device can be also be re-
named using the thermostat as well.
When naming smart devices no blank
spaces or special characters are allowed.
10. Conrm all information listed on the screen is
correct. Select Finish.