User Guide

14
been fully commissioned and the rst
smart device is added.
Equipment Settings
Air Handler
Thermostat
Sensors
Zoning Control
Heat Pump
Add/Remove Equipment
Humidifier
Add Sensors
Reset
Connected to System Name S40 0001
Add Extender
To create the smart devices
network and to add the first
smart device use the following
procedure.
1. Verify that the SAQM side
switch is set to the ON (Up)
position.
2. Open the Lennox Smart
Technician App and navigate
to Dealer Service Center and
select Equipment Settings.
3. Apply power to the smart
device and then mount to the
wall.
4. Under Devices, select Add Devices
IMPORTANT
DO NOT interrupt the adding of the smart
device. If interrupted the smart device will need
to be factory-reset.
5. The Create Smart Devices Network will
appear. Select the right arrow at bottom right
corner of screen to continue.
NOTE: This screen will only appear once during
the initial smart device being added.
Wireless Sensors
Create Lennox Sensor Network
Connected to System Name S40 0001
Cancel
In order to add sensors for the first time, tap
Next to create a Wireless Sensor Network.
PAIRING BUTTON
ON/OFF SWITCH
PAIRING LED INDICATOR
6. The Wireless Sensor Add screen will
appear. Now press the pairing button on the
smart device. Verify that the smart device's
green light is ashing which indicates it is in
pairing mode.
7. The Lennox Smart Technician App will
start searching for the SAQM. Select the right
arrow at the bottom of the screen to continue.