User Guide

13
Adding SAQM

1. Only the S40 Smart Technician App can be
used to create the smart devices network.
Both S40 Smart Technician and Smart
Thermostat Apps can be used to add/re-
move sensors.
2. When adding or removing the SAQM the S40
Smart Technician or Smart Thermostat
Apps (mobile device) will need to be within
10 feet (3 meters) of the thermostat.
3. If the SAQM just added does not appear
under the (Equipment List or My Home)
screens, then allow a few minutes to past be-
fore checking again.
4. Do not switch back-and-forth between your
mobile device's screens during the adding or
removing procedure.
5. If adding a SAQM which will be out of direct
range of the thermostat and will connect via
a Lennox Wireless Extender, then the Len-
nox Smart Technician or Thermostat Apps
do not required the user's mobile device to be
near the thermostat for the adding or remov-
ing procedure.
6. Always give each SAQM a unique name.
7. After removing a functional SAQM, make sure
to perform a factory reset.
8. In case the adding procedure fails, then al-
ways perform a factory reset on the SAQM
before trying to add it again.

LENNOX SMART TECHNICIAN APP
Devices
Dealer Service
Center
Equipment
Settings
Add Devices
Provisioning done in
the backgrorund
Follow Screen
Prompts
Figure 5. Adding Smart Device Flow Process
NOTE: The thermostat smart devices network
is inactive until the S40 thermostat has