User Guide

Figure 25. Setup New Device

3. Select the iComfort device to continue.

4. Under Accessory Setup, you should see a message indicating the

accessory will be set up to join “your local network”.

5. Press Next to continue. If successful, you should see a accessory join

message.

Apple HomeKit Pairing

1. To add the thermostat to a speci c home if you have more than one. Go

to your Apple Home application on your mobile (iOS) device and FIRST

select the home.

Figure 26. Typical Example of Home Selection.

2. Select Add Accessory.

3. Select either a iComfort E30 or S30.

Figure 27. Typical Example of iComfort Accessory Selection

4. The following screen will appear on your Thermostat. Use your iOS device’s

camera to read the pairing code that appears on the thermostat’s screen.

NOTE: If your camera is unable to read the code, you will be given the

opportunity to manually enter the code

Figure 28. Pairing Code

NOTE: You have 15 minutes to complete the procedure or it will time out at

the thermostat.

5. The following screens will indicated the pairing was successful.