User Guide

NOTE: You have 15 minutes to complete the procedure or it will time out at the

thermostat and you will receive a WAC Failed message.

2. Proceed to “HomeKit Manual Setup” to continue the procedure.

HomeKit Manual Setup

The following procedure is used when Apple Homekit was not con gured

during the thermostat’s commissioning phase. This procedure could also be

used if the thermostat had been con gured by a previous homeowner.

1. From the thermostat’s home screen, go to menu > settings > Home Kit.

Select HomeKit factory reset.

Figure 22. HomeKit Menu

2. A pop-up screen will appear asking you to con rm that you want to reset to

default. Select YES to continue.

Figure 23. HomeKit Reset Screen

3. The following screen indicates that the thermostat is ready for con guring

iOS device to begin WAC.

Figure 24. Wi-Fi Con guration

Wi-Fi Accessory Conﬁ guration (WAC)

1. The Wi-Fi Accessory Con guration (WAC) Active screen provides three

setup status indicators. Those are:

• Unit is ready for Con guring iOS device to begin WAC.

• Destination Wi-Fi network has been received from Con guring iOS

device and is being applied.

• Almost done, checking for Internet connection before exiting.

NOTE: You will receive an error message indicating “network not con gured”

if the procedure failed.

NOTE: If there is no Internet connection available, your will get an error

message indicating “Internet connection not available”.

2. Go to your iOS device’s Wi-Fi utility and look for either a E30 or S30 and

a unique ID (example: S30 e0fc37). Select that SSID. Under Setup New

Device, you should see iComfort S30 e0fc37.

NOTE: Please note that e0fe7 is an example and is a variable. Each iComfort

E30 or S30 thermostat will have its own unique alpha-numeric

sequence.