User Guide

16
Peak Monitoring
NOTE: This feature requires thermostat rmware version 3.70.xxx or higher.
Go to menu > settings > general > about to verify your thermostat
rmware version.
Peak Monitoring is currently a feature requirement for the State of California.
Enrolling into the energy saving program will allow your utility company to
control your thermostat during peak energy events. An icon on the home page
will indicate when the system is in an active energy savings event. Enrollment
is a two-step process for consumers. The rst step requires the consumer to
register with their utility provider before the thermostat settings can be enabled
to take advantage of the Peak Monitoring feature.
Enable Peak Monitoring
Go to Menu > Settings > Peak Monitoring and turn on enable energy savings.
This will automatically get the required certication for your thermostat.
away on
auto
Feels Like
fan
heat & cool
humidity
iHarmony zoning
general
display
settings
notifications
home info
name
account
System
advanced settings
HomeKit
on
autoventilation
Peak Monitoring
Peak Monitoring
upstairs
wi-fi local
In order to enroll for Peak Monitoring with your provider,
you must enable this feature first, one time only.
Peak Monitoring settings
>
enable Peak Monitoring
Figure 13. Peak Monitoring Savings
NOTE: If enabling energy savings is successful or not successful a pop-up
screen will appear indicating either. If unsuccessful, try again in a few
minutes.
Enroll in Peak Monitoring
The next screen will allow you to enroll in energy savings. Follow the on-screen
prompts to continue. Detail on-screen instructions are provided.
1. Toggle enable Peak Monitoring to ON. A pop-up message will appear
asking wanting you to rst verify that your utility provider has a Demand
Response Program. If they do, select OK.
2. In the next screen, write down the registration code listed and then select
OK.
3. On this screen, select “enroll Peak Monitoring”, and type in the URL
provided by your energy provider and then select DONE.
away on
auto
Feels Like
fan
heat & cool
humidity
iHarmony zoning
general
display
settings
notifications
home info
name
account
System
advanced settings
on
autoventilation
Peak Monitoring
Peak Monitoring
Please visit your energy provider website to get a registration URL,
and then press enroll. You may be asked to provide a registration code.
upstairs
wi-fi local
cancel
Peak Monitoring enrollment done
https://vtn.com
Enter the website address (URL) your energy provider sent you.
HomeKit
Figure 14. Peak Monitoring Enrollment
5. If enrollment is successful, the next screen will indicate enrollment status
as enrolled and connection status as connected.
Peak Monitoring Settings
This screen will allow you to use your energy provider’s default temperature
or pricing set points. You can also customize these settings by selecting the
following.
1. Peak load event active set-points with the following options:
• Default
• Offset.
• Custom set-points
• Peak Price event Threshold
2. Peak Price Event Active Set-points with the following options:
• Default
• Offset.
• Custom set-points
• Peak Monitoring Events Filter