User Guide
11
NOTE: Smart away will be canceled when the system is enrolled in energy
savings with a utility provider and a energy saving event is active.
Mobile Device Location Services Settings for Smart Away
Android Version 10 and 11 Location Services Settings
1. Starting with Android version 10, when allowing the mobile app access
to device location you must select “Allow all the time” for the Smart Away
feature to work correctly go to Settings > Apps > iComfort > Permissions
> Locations > Allow all the time setting is enabled.
2. Starting with Android version 11, to ensure location services for the
iComfort
®
Smart Away feature are not auto disabled by Android operating
system, go to Settings > Apps > iComfort > Permissions > “Remove
permission if app isn’t used” and ensure this setting is disabled (see gure
below).
IOS 12, 13, and 14 Location Services Settings
1. Location services will need to be enabled for this feature to work. Go to
Settings > Privacy > Location Services > Location Services.
2. Select Always Allow for Smart Away to control the temperature in your
home while you are away
3. Select Always Allow with Precise Location Enabled for Smart Away to
control the temperature in your home while you are away.
4. Select Allow While Using App for Smart Away to control the temperature
in your home while you are away..
Feels Like
The feels like feature uses a combination of outdoor temperature and indoor
humidity to come up with the feels like comfort level in the home.
NOTE: Feels Like is not a temperature setting but the temperature that the
space feels like based on current outdoor temperature and indoor
humidity. To adjust Feels Like, lower indoor temperature, or both
indoor temperature and humidity percentage settings.
NOTE: When Feels Like is set to on, the words Feels Like will appear above
the indoor temperature display on the home screen.
feels like
feels like
Display and control your system using feels like temperatures instead of actual temperatures
on
indoor
humidity
indoor
temperature
outdoor
temperature
feels like
++
Feels like temperatures factor in the outdoor temperature
and indoor humidity for more accurate control of the temperatures in your home
= 75°
Figure 10. Feels Like Screen
Fan
Allergen Defender: Go to menu > settings > fan to turn on or off Allergen
Defender. Internet weather must be enabled and the pollen count is high for
the following pollens (Grass, Ragweed, Mold, Tree and Overall Pollen) the fan
will run between heating or cooling demands to help clean the air. Works best
with MERV 11 or higher lter.
Fan Mode Options: Circulate air can be adjusted on this screen. Adjustments
between 9 to 27 minutes on how long the air will circulated each hour. The
circulate option runs during any mode selected except when the system is
turned off.
Ventilation
This option will only appear if a fresh air damper, ERV or HRV is installed and
congured by your installer. Either ERV or HRV could be congured as single
or two-stage if applicable.
Menu Selection
When selecting this menu option, selections will be either:
• Timed or ASHRAE (either Timed or ASHRAE is set by your installer during
setup of your thermostat).
• On (always)
• Off (always).
Factory default is ASHRAE. Your installer will need to change it to Timed if that
mode is desired.
You can also select “ventilate now” to start a ventilation function immediately.
Those menu options are 10, 20, 30, 40 and 50 minutes, 1 hour, 1-1/2 hours, 2
hours, 2-1/2 hours, 3 hours, 3-1/2 hours and 4 hours and custom. Custom will
allow to set a specic time to run too.