Install Instructions

ManualsBrandsLennox ManualsHVAC Replacement PartsiComfort S30 Ultra Smart Programmable Thermostat

100

Table 19. Alert Codes and Troubleshooting

GF= Gas Furnace, AH=Air Handler, ID=Indoor unit (GF or AH), HP=Heat Pump, AC=Air Conditioner, OD=Outdoor Unit (AC or HP), PA=Pure Air S, ZA=Zone system and TS=Thermostat

Alert

Code

Inverter

Flash

Code

Priority

Condition

Actual Displayed

Alert Text

Under dealer

control center >

Notications

Component or System Operational State and Troubleshooting Tip How to clear alert code

65544

Information

Only-Dealer

More Than

8 Tstats In A

Group

The system is limited to no more than eight (8) smart hubs assigned to one group. You can have

up to nine groups (1-9) with ve smart hubs assigned to each. If you have more than 8 smart hubs

assigned to a single group, then alert code 65544 will be displayed.

If you DO NOT exceed the ve smart hubs per group limitation, you will NOT get an alert code

65544.

EXAMPLE: If you had two groups with six smart hubs assigned to each group, then you would

get each minute twelve alert code 65544 notications.

Once the system detects that only

ve or less smart hubs are detected

in one group will the alert code

automatically clears.

65545 Service Soon

Cooling

Capacity Alert

Cooling operation may not be sufcient for the hottest days. Based on local conditions and

climatological data for zip code.

EXAMPLE: Dirty Filter, Low Refrigerant charge, TXV, etc. Symptom during mild temperatures

may include; system running longer than normal but not showing any other symp-

toms.

Auto cleared on next prediction

-- Service Soon --

Possible loose or mis-wired connections or two zone sensors are assigned the same zone

number. Two dashes will be displayed on the S30 thermostat for indoor temperature and/or zone

sensor. The system will go into central mode. Individual zone functions is disabled. Anytime the

zone sensor loses communication with the damper control module, the entire system will go into

central mode. If two sensors are assigned the same zone number, this could result in the double

dashes to appear as well.

If two zone sensors are assigned

the same zone number, this could

cause the double dashes to appear.

If loose or mis-wired connection was

conrmed, correct the issue and run

the re-conguration procedure.