Instruction manual

Clock setting mode works in stop mode
1. HoldthePROGRAM/MEMORY/CLK-ADJ.buttonclockmode12or24hourswillash.
2. Press the B - SKIP or F - SKIP button to adjust 24 - hour or 12 - hour clock mode.B - SKIP or F - SKIP button to adjust 24 - hour or 12 - hour clock mode.or F - SKIP button to adjust 24 - hour or 12 - hour clock mode.F - SKIP button to adjust 24 - hour or 12 - hour clock mode.button to adjust 24 - hour or 12 - hour clock mode.
3. PressthePROGRAM / MEMORY / CLK - ADJ. button again, the hour digit will ash on the display.PROGRAM/MEMORY/CLK-ADJ. button again, the hour digit will ash on the display.buttonagain,thehourdigitwillashonthedisplay.
4. PresstheB - SKIP or F - SKIP button to adjust the hour digit.B-SKIPor F - SKIP button to adjust the hour digit.orF - SKIP button to adjust the hour digit.F-SKIP button to adjust the hour digit.buttontoadjustthehourdigit.
5. PressthePROGRAM / MEMORY / CLK - ADJ. button again, the minute digit will ash on the display.PROGRAM/MEMORY/CLK-ADJ. button again, the minute digit will ash on the display.buttonagain,theminutedigitwillashonthedisplay.
6. PresstheB - SKIP or F - SKIP button to adjust the minute digit.B-SKIPor F - SKIP button to adjust the minute digit.orF - SKIP button to adjust the minute digit.F-SKIPbutton to adjust the minute digit.buttontoadjusttheminutedigit.
7. PressthePROGRAM / MEMORY / CLK - ADJ. button again, the correct time will be shown on the display.PROGRAM/MEMORY/CLK-ADJ.button again, the correct time will be shown on the display.buttonagain,thecorrecttimewillbeshownonthedisplay.
CLOCK SETTING
GB 7
WARNING
ShouldtheCDdoorbeopenedbeforethereadingoftheCD
iscompleted,ajammingnoisemayoccur.Thisisresolved
byclosingtheCDdoor.
CLEANING THE UNIT
Do not use volatile chemicals
onthisunit.Cleanbylightly
wipingwithasoftcloth.
IMPORTANT NOTE
Ifanabnormaldisplayindicationoranoperatingproblem
occurs, disconnect the AC power cord and remove the
batteries. Wait at least 5 seconds, then reconnect the AC
power cord or reinstall the batteries.
CLEANING CD
IftheCDskipsorwillnotplay,thediscmayneedcleaning.
Before playing, wipethe disc fromthe centreout with a
cleaningcloth.Afterplaying,storethediscinitscase.
MAINTENANCE
CLEANING THE CD LENS
If the CD lens is dusty, clean it with a brush-blower. Blow
several times on the lens and remove the dust with the
brush.Fingerprintsmay beremovedwithacottonswab
moistened with alcohol.
INTRO
InCDmode,presstoplayonlytherst10secondsofeachtrackonthedisc.
SCD-11 NO IPOD LENCO ENGLISH rev9 9 4/12/2009 10:24:26