Datasheet

11
OPERATION
EQUALIZATION
Press P-EQ button (25) to turn on
equalization function and to select
desired audio mode. There are five kinds
of mode as below:
FLAT CLASSICS POP M ROCK M DSP OFF
LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated
functions on the display (8).
FLASHING LED
If the front panel does not install in the
unit, the LED (26) will be flashing.
AUXILIARY INPUT
The unit can be connected to a portable
audio player through the AUX IN jack
(24)
REMOTE SENSOR
Point the remote control handset to the
remote sensor IR (25). Press the function
keys on the handset to control the
system.
RESET FUNCTION
RESET
button (27) must be activated
with either a ballpoint pen or thin metal
object.
The RESET button is to be activated for
the following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: If press RESET button (29), the
unit can’t work yet, please use a cotton
swab soaked in isopropyl alcohol to
clean the socket on the back of the front
panel.
RADIO OPERATION
• SWITCHING TO RADIO MODE
Press MODE button (6) shortly to
select radio mode, the radio mode
appears in the display together with
the memory band and frequency.
• SELECTING THE FREQUENCY
BAND
At radio mode, press BND/LOU button
(13) shortly to select the desired band.
The reception band will change in the
following order:
FM1 FM2 FM3 MW
• SELECTING STATION
Press SKIP/MANU button (16)
or SKIP/MANU
button (17)
shortly to activate automatic seek
function. Press for several seconds
until “MANUAL” appears on the
display, the manual tuning mode is
selected. If both buttons have not
pressed for several seconds, they will
return to seek tuning mode and
“AUTO” appears on the display.
• AUTOMATIC MEMORYSTORING &
PROGRAM SCANNING
- Automatic memory storing
Press AS/PS button (18) for several
seconds, the radio searches from
the current frequency and checks
the signal strength until one cycle
search is finished. And then 6
strongest stations are stored into the
corresponding preset number
button.
- Program scanning
Press AP/AS button (18) shortly to
scan preset station. When the field
strength level is more than the
threshold level of stop level, the radio
is holding at that preset number for
several seconds with release mute,
then searches again.
• STATION STORING
Press any one of the preset buttons
(14) (1 to 6) to select a station, which
had been stored in the memory. Press
this button for several seconds, (until
2’nd beeps come out), current station
is stored into the number button.