BTT-100 SpeakerTower with Bluetooth® User's Guide www.lenco.com 201307 v1.
Important safety instructions The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. When the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. To be completely disconnected the power input, the mains plug of the apparatus or the appliance coupler shall be disconnected from the mains completely.
Description of parts 2 4 1 6 3 8 7 9 5 10 11 12 13 14 15 17 16 18 2 MAIN UNIT 1. TUNING- & PREVIOUS/FAST BACKWARD BUTTON 2. VOLUME+ BUTTON 3. VOLUME- BUTTON 4. PLAY/PAUSE BUTTON 5. STANDBY BUTTON 6. TUNING+ & NEXT/FAST FORWARD BUTTON 7. BT PAIR BUTTON 8. MODE BUTTON 9. STOP BUTTON 10. BLUETOOTH INDICATOR 11. REMOTE SENSOR 12. LCD DISPLAY 13. AC SOCKET 14. POWER ON/OFF BUTTON 15. SD CARD SLOT 16. USB PORT 17. AUX IN JACKS 18.
REMOTE CONTROL 1. TONE/CH+ BUTTON 2. VOLUME-/STOP BUTTON 3. TUNING- & PREVIOUS/FAST BACKWARD BUTTON 4. BT PAIR & PLAY/PAUSE BUTTON 5. STANDBY/MUTE BUTTON 6. FUNCTION/CH- BUTTON 7. VOLUME+/INFO BUTTON 8. TUNING+ & NEXT/FAST FORWARD BUTTON 9. MEMORY/RANDOM BUTTON 1 2 3 4 5 7 BT 8 9 6 Installation AC POWER CONNECTION 1. Plug one end of the AC cord into the AC socket on the unit 2. Then connect the other end to the main power.
RE-CONNECT TO THE BLUETOOTH AUDIO SOURCE DEVICE (UNDER BLUETOOTH MODE) If the device is already paired with the Lenco BTT-100, but became unconnected even with both Bluetooth® devices turned on. You can re-connect them by following steps: 1. Press the BT button on the unit or press and hold BT button on the remote to re-link the audio source device. The Bluetooth® indicator will blink for connecting. 2. Select Lenco BTT-100 on the audio source device for connecting.
again to resume the audio. During playback, press and hold STANDBY/MUTE button on the remote to enter standby mode. VOLUME LEVEL ADJUSTMENT Press the VOLUME +/- button to adjust the volume output level. TONE SETTING FOR THE UNIT During playback, press the TONE button on the remote once, and use the VOLUME+/- button to adjust the bass. During playback, press the TONE button on the remote twice repeatedly, and use the VOLUME+/button to adjust the treble.
Troubleshooting Symptom Radio sound distorted. Possible Cause 1. The station is not tuned in. 2. There is a poor signal in the area. No radio sound. 1. The unit is not in tuner mode. 2. The volume has been muted or is on the minimum setting. Sound distorted while playing card or USB. No sound at Bluetooth mode. 1. The original audio file is distorted. 1. The Bluetooth device is not paired with the unit. 2. The volume has been muted or is on the minimum setting. Solution 1.
Notice, statement and information Manufacturer of this unit follows a principle of continuous improvement and has no responsibility for any changes that are made to the unit nor any liability for these changes. Lenco is not liable for printing errors in the manual. The specifications and external appearance of the set are subject to change without prior notice. This symbol indicates that the relevant electrical product or battery should not be disposed of as general household waste in Europe.
