User's Manual

8
9
CAN ICES-3 (B) / NMB-3(B)
This device complies with Industry Canada license-exempt RSS Standard(s). Operation is subject to the
following two conditions: (1) this device may not cause Interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
_ no naked flame sources such as lighted candles should be placed on the apparatus;
_ the use of apparatus in tropical climate
This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FFC RF Radiation Exposure Statement Caution: To maintain compliance with the FCC’s RF exposure
guidelines, place the unit at least 20 cm from nearby persons.
Caution regarding placement
To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer
dimensions including projections) that is equal to or greater than shown below.
_ Left and Right Panels: 10 cm
_ Rear Panel: 10 cm
_ Top Panel: 10 cm
Applies only to Pulse 2 and Pulse Mini
Caution
Marking and rating plate are located at the rear enclosure of the apparatus.
WARNING – IF THIS PRODUCT IS USED AT 240VAC, A SUITABLE ATTACHMENT PLUG SHOULD BE USED.
_ Heat - The product should be situated away from heat sources such as radiators, heat registers, stoves
or other products (including amplifiers) that produce heat.
Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
Warning
To reduce the risk of fire or electric shock, do not expose this product to rain or moisture.
Caution
To prevent electric shock, match wide blade of plug to wide slot, fully insert.
Warning
Main plug is used to disconnect device and it should remain readily operable during intended use.
Caution
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
RESPONSIBLE PARTY
Lenbrook Industries Limited, 633 Granite Court, Pickering, Ontario L1W 3K1
Warning
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
_ Reorient or relocate the receiving antenna.
_ Increase the separation between the equipment and receiver.
_ Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
_ Consult the dealer or an experienced radio/ TV technician for help.
English
14-108_BLS_Safety Guide_2014_K_September-17-2015.indd 8-9 2015-09-25 4:59 PM