Datasheet

39www.lemo.com

Cable assembly

Terminating of plugs and straight sockets with cable collet

M3M2M1

± 0.2

1. Cable preparation

First place the bend relief (if to be used) on the cable.

Strip the cable according to dimensions below.

2. Cable termination

2.1 Place the collet nut ➀ and the collet ➁ on the cable. Fold back the

shield braid onto the conical part of the collet, and trim to the outer

edge of the collet

2.2 Slide the subassembly ➂ to trap the shield braiding and solder the

central conductor into the contact.

Straight plug

Free socket

Fixed socket

nut fixing

Crimp

2.3 Slide the insulator ➃ onto the subassembly ➂ until it rests against

the earthing sleeve of the subassembly ➂.

2.4 Slide the assembly into the connector outer shell ➄. Screw the

collet nut ➀ into the connector outer shell ➄ using the appropriate

tool and tighten to a torque of 0.25 Nm (see “Tooling” on page 35,

36 and 37). Push the bend relief (if used) onto the collet nut.

Cable

group

1-2-3-4-8

6-7

TSL

44.59

–––

TSL

–––

7.5 8.5 13

TSL

558

–––

Note: these terminating instructions apply to the following models:

M1 = FFA, FFE, FFF, PCA, PSA

M2 = FFY

M3 = FFC