Datasheet

LEM reserves the right to carry out modications on its transducers, in order to improve them, without prior notice.
www.lem.com
Page 3/3
090616/8
Connection
Dimensions LA 100-TP (in mm. 1 mm = 0.0394 inch)
Front view
Top view Left view
Mechanical characteristics
General tolerance ± 0.2 mm ●
Fastening & connection of primary bus bar ●
6.4 x 1.6 mm
Recommended PCB hole 3.8 mm
Fastening & connection of secondary 3 pins ●
0.6 x 0.7 mm
Recommended PCB hole 0.9 mm
Remarks
I ●
S
is positive when I
P
ows in the direction of the arrow.
Temperature of the primary conductor should not exceed ●
100°C.
This is a standard model. For different versions (supply ●
voltages, turns ratios, unidirectional measurements...),
please contact us.
Secondary terminals
Terminal + : supply voltage + 12 .. 15 V
Terminal - : supply voltage - 12 .. 15 V
Terminal M : measure