Replacement Part List
ASSEMBLY
HOW TO ASSEMBLE THE SILVERSKIN KNIFE:
• With the knife unplugged, the trigger in the locked position and the cut resistant glove on the hand you will use to install
the knife blades; pair 2 of the knife blades together by matching the keyhole with the pin on the opposing knife.
• Place knife protective sleeve over the blades.
• With your gloved hand rmly hold the 2 blades together.
• Press the ends of the knives into the holes at the top of the handle until you hear them click into place.
• Knife is ready for use.
REMOVING THE KNIVES:
• With the knife unplugged, the trigger in the locked position and the cut resistant glove on the hand you will use to remove
the knife blades, press and hold the blade locking mechanism that is just under the knife blades.
• Firmly grasp the knives from the backside of the blades and pull upward to remove.
INSTALLING GUIDES:
Included with your silverskin knife kit are 2 guides. They are labeled on the back of the guide holders;
• 1 for silver skin
• 2 for jerky, or thicker cuts
While holding the guide by the black piece line up the guide holder with the black cap on the left side of the knife set. Slide
the guide in place from the bottom up. There is a locking pin on the left black cap on the knife that must be in the down
position before the guide can slide fully into place. This pin is a pop-up pin that works like an ink pen. After the guide is fully
in place press the pin to lock the guide securely in place.
TO REMOVE GUIDE:
Simply press the locking pin so it is in the down position and slide the guide down away from the knife blades.
PARTS
A
B
C
D
ITEM PART DESCRIPTION
Safety Lock
Guide Lock
Speed Control
Knife Lock
LEM Products • West Chester, OH 45011 • 877-536-7763 • lemproducts.com LEM Products • West Chester, OH 45011 • 877-536-7763 • lemproducts.com
4 5
SILVER SKIN REMOVAL
• Once the knife is properly assembled, safety on and plugged into a properly grounded outlet you are ready to start
processing.
• The knife has a speed control on the back of the handle. Use the speed that works best for you.
• Using the tip of the knife blade poke just under the silver skin and make a 1-2” cut to create a tab you can grasp
with the pliers.
• Lift the tab and pull so there is tension on the silver skin.
• With knife blade under the silver skin tab and the guide on top, press the trigger and pull the silver skin with the pliers
while turning the knife blade slightly up towards the silver skin and run the blade in a smooth even cut. (Image A)
• It may take a little practice but once the technique is perfected you will never go back to your old processing ways.
PLIERS
CAUTION
When changing blades or preforming any maintenance press the safety on the trigger
and unplug from the electric supply.
VIDEO
WATCH OUR VIDEO AT
lemproducts.com/silverskin-knife
1
1
1
QTY
1
1
2
3
4
5
6
# DESCRIPTION
Knife handle
Blades
Pliers
Cut Resistant Glove
Silverskin guide #1
Jerky guide #2
1
2
17
Case
Image A