User Manual

GiuliettaX - PL2SVX*
8
Attention. Once the machine has been installed and is ready for use, before allowing the
operator to start using the machine, wash the internal components by following the instructions below.
EXTRACTION GROUPS
Hook up the lter holders to the groups (without coffee).
Let each group dispense water for about a minute.
HOT WATER
Continuously dispense hot water (by opening the relative knob) until at least 4 liters of water come
out of the machine.
STEAM
Dispense steam from the nozzles for about a minute, using the appropriate knob.
8. Information for end user/operator
8.1 First steps
Attention. Before you start operating
the machine, wash the internal components
following the instructions indicated below.
These steps must be repeated at least once
a day and when the machine has not been
operated for more than 8 hours.
Attention. For a correct programmed
cleaning procedure follow the indications
described in chapter “15. Cleaning and
maintenance”.
EXTRACTION GROUP
Hook up the lter holders to the groupsheads
(without coffee).
Let each group dispense water for about a
minute.
HOT WATER
Continuously dispense hot water (by opening
the relative knob) until at least 4 liters of water
come out of the machine.
STEAM
Dispense steam from the nozzles for about a
minute, using the appropriate knob.
8.2 During daily use
The machine can work on 3 different
temperature proles, according to the periods
of non-use.
O F F
(8.1)
T e m p e r a t u r e
E N A B L E D
(8.2)
The temperature measure unit can be set
from the technical menu: enter the OFF mode
(Pic. 8.1) (K5GR1+K3GR1 and keep K5GR1
pressed for 10 seconds), scroll the menu by
pressing the K5GR1 until you reach the screen
13, where you have the possibility to enable or
disable the temperature function by pressing
K1GR1 or K2GR1. Conrm selection by
pressing K5GR1 (Pic. 8.2).
° c
T e m p e r a t u r e
(8.3)
B o i l e r
1 2 5 ° C
T e m p e r a t .
(8.4)
In the following screen (screen 14) you can
choose the temperature measure unit (°C/°F)
by pressing K1GR1 or K2GR1 (Pic. 8.3).
Conrm selection by pressing K5GR1.
In the screen 15 you can use the K1GR1 and
K2GR1 to set the temperature value that the
boiler will reach during the use of the machine
(this value is between 110°C and 130°C).
Conrm selection by pressing K5GR1 (Pic. 8.4).
This temperature value will determine the steam