User Manual
English
13
EN
13.4 13.5
3. Once the desired quantity of coffee for that dose is reached, press the selected button again and
the serving dose will be memorized. The machine will go back to doses programming mode. At the
same time, the LED of the programmed dose will go off and the LED of both K5 buttons will blink; now
it’s possible to program the other doses without repeating the operation described in point 1.
4. To program the other doses (if the time-out of 30 seconds has not elapsed yet) repeat points 2 and 3
consequently.
If the time-out of 30 seconds has already elapsed and you are out of the programming mode, you need to
repeat all the operations of points 1-2-3 to enter in the programming mode again.
To exit the programming mode without modifying any of the parameters just wait for 30 seconds, without
pressing any button.
IMPORTANT: what has been programmed on the FIRST GROUP is ALWAYS automatically
transferred also TO THE OTHER GROUP. This does not mean that you cannot program the other
group independently from group 1, you can do so by repeating the operations in points 1-2-3 also
on the other group.
13.2 Washing cicle
The washing cycle enables the cleaning of the extraction groups and can be performed
as follows:
13.6
A B
Press the continuous/stop button (K5GRx) (A)
and then the switch (K1GRx) (B) of the group
where you want to perform the washing cycle
(Pic.13.6).
The washing cycle will be conrmed by the
synchronic blinking of the relative LEDs of the
2 buttons that you have pressed one after the
other (K5GRx + K1GRx); the blinking will continue during the entire washing cycle and will stop if
any of the other switches of the same panel will be pressed. In this case the washing cycle will be
interrupted and the LEDs will go back to the ON position. It’s possible to undergo the washing cycle
using an appropriate detergent powder (see chapter 15).
The extraction group that undergoes the washing cycle will dispense water 5 times through the group.
Once the cycle is over, the selection panel will go back to the normal functioning mode.
It’s possible to do the washing cycle at the same time on both groups, as many times as desired
during the working day.
In chapter 15. CLEANING AND MAINTENANCE you’ll nd out how to perform the washing cycle with
the recommended detergent powder.