Use and Care Manual
A. BEFORE LIGHTING, smell all around the unit
because some gas is heavier than air and will
B. WHAT TO DO IF YOU SMELL GAS
1. Shut off the gas to the appliance.
ame.
3. If odor continues, immediately call your gas
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will not
push in or turn by hand, DO NOT try to repair it.
explosion.
FOR YOUR SAFETY, READ BEFORE LIGHTING
1. STOP! Read the safety information above.
2. Push and slowly turn the control knob to the HIGH
position .
3. Hold ignitor to light the burner , release control knob
after 45 seconds.
4. Observe the flame height when lit. Flame should
be 3 to 13 inches high .
5. If the burner does not light before the match goes
out, immediately turn the control knob to the OFF
position.
6. Wait approximately five minutes to clear out any gas,
and repeat steps 1-4 above.
7. If your burner fails to light again, turn the control
knob to the OFF position and contact your dealer
or gas supplier.
8. To extinguish your gas burner, turn the control knob
to the OFF position. Be sure the control knob is
turned fully off to avoid any gas leakage.
ELECTRONIGNITIONINSTRUCTIONS
OPERATING THE UNIT - LIGHTING AND EXTINGUISHING
MANUAL (MATCH) LIGHTING INSTRUCTIONS
1
1
26
(See P1)
(See P1)
P1
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT, CAUSING PROPERTY
DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.