Use and Care Manual

INSTALLATION (Cont.)
LOCATION
While following all requirements and safety information in this
manual; locate the unit on a at, level surface.
CONNECT TO A PROPANE CYLINDER GAS SUPPLY
Important: Before installation, be sure the propane
cylinder is turned off.
Install the regulator hose assembly to the unit
using a gas pipe sealing compound or Te on Tape. Then
attach the regulator end to the propane cylinder and tighten
(see Fig. 10-1). Follow all instructions and safety warnings
supplied with the propane cylinder.
CONNECT TO A NATURAL OR HOUSEHOLD PROPANE
GAS SUPPLY
1. Connect a ex connector to the unit using a
gas pipe sealing compound or Te on Tape (see Fig. 10-3).
2. Bring the gas-supply pipe up from beneath the unit near
its center.
Note: Locate the gas supply line out of pathways where
people may trip over it or in areas where the line may
be subject to accidental damage.
3. Install a are adaptor to the gas supply (NPT) using a
gas pipe sealing compound or Te on tape (see Fig. 10-
3).
4. Connect the ex connector to the are adaptor (see Fig.
10-3).
LEAK TEST
Turn on the gas supply, ignite the burner, and test at all
connections for leaks using a soapy water solution. If bubbles
appear, a leak is present. Turn off the gas and tighten at all
connections. Repeat until no leaks are present. If a leak
persists, turn off the gas supply and contact the local gas
company or dealer. NEVER USE A FLAME TO CHECK FOR
LEAKS.
Fig. 10-3
Gas supply
Flare adaptor
Flex connector
(coming from unit)
U
L
Propane
cylinder
Regulator hose assy
(coming from unit)
U
L
Fig. 10-1
Fig. 10-2
*The฀gas฀hose฀connector shall
have฀a฀ connector that complies with the
Standard for Gas Hose Connectors for Portable Outdoor Gas-Fired Appliances,
Place the cylinder in the tank seat, and rotate the screw
clockwise to a fully stop. (see Fig. 10-2).
1
1
22