Owner’s Manual OUTDOOR FIRE PIT TABLE 1
CONTACT US We hope that you enjoy your products. Thanks for your purchase.
INSTALLATION STEPS OF FIREPIT TABLE List of Parts for 1set of Firepit Table 3
Step 1---Installation of Firepit Table 5
Step 2---Installation of Firepit Table 6
Step 3---Installation of Firepit Table 7
Step 4---Installation of Firepit Table 8
Step 5---Installation of Firepit Table 9
Step 6---Installation of Firepit Table 10
Step 7---Installation of Firepit Table 11
Model #:FTF44-H-E series WARNING: For Outdoor Use Only. *Conversion kit required Important: ? ! # # CODE AND SUPPLY REQUIREMENTS: ! $ T ! ! WARNING ## ! # + # # ! ! ! # @ !J # # # # ! + # # # ! National Fuel Gas Code, ANSI Z223.
PARTS LIST NO. DESCRIPTION 1. Firepit 2. Burner pan assembly (natural or propane) 3. Control knob assembly Fig.
SAFETY INFORMATION DANGER DANGER · · EXPLOSION - FIRE HAZARD Keep solid combustibles, such as building materials, paper or cardboard, a safe distance away from the fire pit as recommended by the instructions. · Provide adequate clearances around air openings into the combustion chamber. · Never use the fire pit in spaces which do or may contain volatile or airborne combustibles, or products such as gasoline, solvents, paint thinner, dust particles or unknown chemicals.
SAFETY INFORMATION WARNING WARNING California Proposition 65 Combustion by-products produced when using this product contain chemicals known to the State of California to cause cancer, birth defects, and other reproductive harm. · This product is fueled by propane gas. Propane gas is invisible, odorless, and flammable. An odorant is normally added to help detect leaks and can be described as a "rotten egg”smell. The odorant can fade over time so leaking gas is not always detectable by smell alone.
PRE-INSTALLATION AND PREPARATION SAFETY GUIDELINES A. Before installing this unit, check the MINIMUM CLEARANCE TO COMBUSTIBLES section to ensure that the surrounding area is properly sized for the installation. B. The unit is for outdoor use only. DO NOT install or use this appliance inside a building, garage, or any other enclosed area, including recreational vehicles and/or boats.
CONVERTING TO A DIFFERENT GAS TYPE (MATCH LIT) To convert propane to natural gas or from natural to propane gas, carefully follow the steps below: 1. SHUT OFF THE GAS SUPPLY TO THE UNIT AND ANY NEARBY ELECTRICAL SOURCES OR APPLIANCES. 2. If present, remove all decorative media from the unit. 3. Remove the screws attaching the burner pan to your enclosure. 4. Carefully detach the ex connector attached to the ori ce holder (see Fig. 1 ) and unscrew the ori ce holder from the burner pipe (see Fig. 1 ).
INSTALLATION SAFETY GUIDELINES A. as necessary. It is imperative that control compartment, burners and circulating air passageways of the appliance be kept clean. B. Carefully inspect for shipping damage. If any parts are damaged, call the dealer. C. Correct installation and proper placement of the unit and decorative media is crucial to the safe performance of the unit. See installation instructions for further information. D.
SAFE USE & MAINTENANCE OF PROPANE GAS CYLINDERS IMPORTANT FOR YOUR SAFETY READ AND FOLLOW ALL WARNINGS PROVIDED WITH THE PROPANE-GAS CYLINDER. When operating this appliance with a propane-gas cylinder, these instructions and warnings MUST be observed. FAILURE TO DO SO MAY RESULT IN A SERIOUS FIRE OR EXPLOSION. CYLINDER/CONNECTOR REQUIREMENTS a. Propane-gas cylinders, valves, and hoses must be maintained in good condition and must be replaced if there is visible damage to either the cylinder or valve.
IMPORTANT SAFETY INFORMATION BE CAREFUL If not installed and used correctly per these instructions, this product can cause serious injury. CAUTION safety precautions and warnings contained in this manual. A. FOR OUTDOOR USE ONLY. THIS UNIT MUST BE INSTALLED AT LEAST 36" FROM ANY COMBUSTIBLE WALLS OR MATERIAL. IT MUST NOT BE INSTALLED UNDER ANY TYPE OF CEILING OR OVERHANG (SEE FIG. 9-1). B. When shutting the unit down—be sure to TURN THE CONTROL VALVE FULLY OFF. C.
INSTALLATION (Cont.) LOCATION While following all requirements and safety information in this manual; locate the unit on a at, level surface. CONNECT TO A PROPANE CYLINDER GAS SUPPLY Propane cylinder Fig. 10-1 UL Important: Before installation, be sure the propane cylinder is turned off. Install the regulator hose assembly to the unit using a gas pipe sealing compound or Te on Tape. Then attach the regulator end to the propane cylinder and tighten (see Fig. 10-1).
ASSEMBLY INSTRUCTIONS READ BEFORE USE! WARNING For Outdoor Use Only! Use Liquid Propane Gas (LP-Gas) Propane cylinders sold separately WARNING Improper installation, adjustment,alteration,service or maintenance can cause injury or property damage. Read the assembly instructions thoroughly before installing or servicing this equipment. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
DANGER Failure to follow the Dangers, Warnings and Cautions contained in this Owner’s Manual may result in serious bodily injury or death, or in a fire or an explosion causing damage to property. WARNING *Do not use this fire pit for cooking. *Do not burn any other materials than are supplied with and intended for use in this fire pit. *Do not pour water into fire pit. *The installation of this product must conform with local codes. *Do not use this fire pit if any part has been under water.
LAVA GRANULE & GLASS CRYSTAL INSTALLATION GUIDELINES A. Carefully inspect the carton for shipping damage. If any parts are missing or damaged, call your dealer. Do not attempt to install the appliance unless all parts are in good condition. B. Correct installation is crucial to safe performance of your Outdoor Fire Pit. C. Due to high temperatures, the Fire Pit must be located out of traffic areas and away from combustibles.
OPERATING THE UNIT - LIGHTING AND EXTINGUISHING FOR YOUR SAFETY, READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT, CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE. A. BEFORE LIGHTING, smell all around the unit because some gas is heavier than air and will C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, DO NOT try to repair it. B.
OPERATION on the proper operation of the unit. A normally operating unit will demonstrate the following characteristics: a) b) Odor-free. CLEANING AND MAINTENANCE section below. CLEANING & MAINTENANCE A. Always shut off the gas to the unit while performing service work. B. Allow the unit to cool before servicing. C. The unit should be inspected regularly. Excessive debris can build up on this unit from leaves, dirt, or other debris.
PLEASE INSERT BATTERY BEFORE USE STEP 1 Twist the Cap STEP 2 Take off the Cap 28
STEP 3 Insert AAA Battery , make sure the positive electrode of the battery is face to you .
