Installation Manual

ProVision 3 Installation Manual
8100-35521-00
Rev. A1
Leidos Security Detection & Automation, Inc. – Proprietary Page 6 of 119
© 2020 Leidos. All rights reserved
Figure 42: Bolt-On Side Frames ..................................................................................................................46
Figure 43: U-clip Installed on Frame ..........................................................................................................46
Figure 44: Cross-Level Check .....................................................................................................................47
Figure 45: Other Column Screws/Bolts Torqued ........................................................................................48
Figure 46: Bottom Outer Radome Angle Bracket .......................................................................................49
Figure 47: Floor Cover Trim and Install Detail ...........................................................................................49
Figure 48: Mounting Bracket Installed on Column .....................................................................................50
Figure 49: Top Outer Radome Angle Bracket with Bolt Inserted (Right) ..................................................51
Figure 50: Motor Brake Release Cable and Detail Showing Jumper Connected ........................................52
Figure 51: Power Input Box ........................................................................................................................52
Figure 52: Power Switch in the On Position ...............................................................................................53
Figure 53: Swing Arm in Calibration Position ............................................................................................53
Figure 54: Antenna Mast Being Attached to Swing Arm ...........................................................................54
Figure 55: Cables Routed Through Swing Arm Hole .................................................................................54
Figure 56: Corrugated Tube ........................................................................................................................55
Figure 57: Connectors on ISU and Cables from Mast Connected to ISU ...................................................55
Figure 58: Cosmetic Mast Wrap Protective Film Being Removed .............................................................56
Figure 59: Cosmetic Mast Wrap Installation ...............................................................................................56
Figure 60: Push-In Rivets Inserted ..............................................................................................................57
Figure 61: Nut Plate ....................................................................................................................................57
Figure 62: Right Entrance/Exit Cover – Top (Left) and Bottom (Right) ....................................................58
Figure 63: Scratch Guard Film Being Removed .........................................................................................58
Figure 64: Outer Windows ..........................................................................................................................59
Figure 65: Outer Window Bracket Support – Top (Left) and Bottom (Center) ..........................................60
Figure 66: Outer Window Bracket Retainer: Overall and Upper and Lower Closeups ..............................60
Figure 67: Floor Center Panel .....................................................................................................................62
Figure 68: Housing Brace Brackets .............................................................................................................64
Figure 69: Cabling Route with Power Input Box, OCP, and Other Cables Together .................................65
Figure 70: Power Input Box in the Lower (Electrical Enclosure End) Position .........................................66
Figure 71: Roof Middle Holes .....................................................................................................................67
Figure 72: Roof Middle Holes (Viewed from Motor/Pulley End) ..............................................................67
Figure 73: Top Side Cover and Clip-On Panel Nuts ...................................................................................68
Figure 74: Top Side Cover Sliding into Entrance/Exit Cover .....................................................................69
Figure 75: Blank Plate and Cable Pass-Through Hole ................................................................................70
Figure 76: Middle OCP Cover ....................................................................................................................71
Figure 77: Plain Middle Cover ....................................................................................................................72
Figure 78: Middle Covers for Barrier Belt ..................................................................................................73
Figure 79: Upper/Lower Cover with Switch/Power Input in Lower Position .............................................74
Figure 80: Top Entrance/Exit Cover ...........................................................................................................75
Figure 81: Inner Radome Top Angle Rail and Attachment Point ...............................................................75
Figure 82: Inner Radome Base Flange Support Bracket and Guide Pin .....................................................76
Figure 83: Scratch Guard Film Being Removed .........................................................................................76
Figure 84: Placement of Inner Radome Edge Support Brackets .................................................................77