Technical data

DISTANCE MEASUREMENT

To measure the distance to an object, it must be

perfectly targeted. To do this, activate the target

mark by pressing the main button (2) once. The tar-

get mark remains lit for about 4 seconds after letting

the main button go. If the button is kept pressed, the

target mark remains lit.

While the target mark is lit, aim the LEICA PINMAS -

TER at the object and press the main button

a sec -

ond time; the distance is then measured and displayed.

The target mark disappears briefly during the

measur

ement. A new measurement can be made at

any time, as long as the target mark is lit, by pres-

sing the main button once again. If the object is less

than 10 m/11yds away, out of range, or does not

provide enough reflection, then _ _ _ appears on

the display.

The LEICA PINMASTER switches itself

off as soon as

he display disappears.

SCAN MODE

With the LEICA PINMASTER, continuous measure-

ments can also be made: If the main button (2) is

held down the second time it is pressed, the unit

switches to scan mode after approx. 0.5 seconds

and then takes continuous measurements. This is

indicated by the changing display: a new measured

value is produced around every 0.5 seconds.

Scan mode is particularl

y practical when measuring

o flagsticks or other smaller targets.

Note:

In scan mode, due to the constant measurements,

the power consumption is greater than for single

measurements.

Inhalt Pinmaster_933-05.qxp:Inhalt Rangemaster.qxp 06.10.2010 15:09 Uhr Seite 24