Technical data

78
Advancing the film to the first frame
12. Advance the film to the next frame by means
of the quick-wind lever (10), and release the
shutter.
13. Pull the film taut by carefully turning the
rewind crank (15) in the direction of the arrow.
The film is being properly transported if the
rewind crank turns in the opposite direction to
the arrow when the quick wind lever is operat-
ed again.
14. Finally, release the shutter again and cock the
shutter for a third time. The frame counter (7)
now shows "1” and, after checking or setting
the film speed (29), the camera is ready to
use.
Rewinding and removing the film
When the last frame has been exposed, the quick-
wind lever can no longer be operated. Before the
film can be removed, it must be wound back into
the cartridge. To do this:
01. Turn the rewind release lever (6) to "R”,
02. swing out the rewind crank, and
03. turn the crank clockwise (in the direction of
the arrow) until you feel slight resistance and
the film is then freed from the take up spool.
04. Now open the base plate,
05. open the camera back, and
06. remove the film cartridge.
6