User Manual

19
Leica EG1150 H – Paraffin Embedding Station
4.6 Electrical connection
4. Instrument Setup
Connecting the power cord
• Connecttheplug(2) of the power cord to the
connection socket (3) on the rear of the in-
strument.
• Plugthepowercordintothewalloutlet.
Fig. 9
1
2
Connecting the foot switch (optional)
• Inserttheplug(4) of the foot switch into the
connecting port (5) on the rear of the instru-
ment.
• Tightenthescrews(6) of the plug.
4 6
3
5
Before connecting the power cord to the foot switch, ensure that the standby switch (1)
(control panel, front) is set to "O" ("O" = OFF).
The instrument MUST be connected to a grounded power socket.
The instrument is supplied with a set of different power cords. Only the power cord intended
for the local power supply (socket) may be used.
Do not use an extension cord.