User Manual

8
Instructions for Use V 2.4 RevD – 10/2012
2. Safety
Warnings – Safety notes on the instrument itself
Safety instructions – transport, installation and operation
• Afterunpackingtheinstrumentitmayonlybetransportedinanuprightposition.
• Beforeconnectingthedevicetoapowersource,ensurethatthevoltageindicatedonthe
type plate matches the voltage available at the place of installation.
• The unit must be connected only with the supplied power cable and only to a grounded
power receptacle. Do not use an extension cord.
• Thepowersockettowhichtheinstrumentisconnectedhastobeneartheinstrumentand
easily accessible.
• This devicemay only be used by trained laboratorytechnicians. Itmust only be operated
for the purpose of its designated use and according to the instructions contained in these
Instructions for Use.
• Safetynotesontheinstrumentitselfmarkedwithawarningtriangleindicatethatthecor-
rect operating instructions (as defined in these Instructions for Use) must be followed when
operating or replacing the item marked. Nonobservance can cause accidents, injuries and/
or damage to the instrument/accessories.
2.2 Warnings
The safety devices installed in this instrument by the manufacturer only constitute the basis
for accident prevention. Operating the instrument safely is, above all, the responsibility of the
owner, as well as the designated personnel who operate, service or clean the instrument.
To ensure trouble-free operation of the instrument, make sure to comply with the following
instructions and warnings.
To prevent damage to the instrument or the specimen, only accessories authorized by
Leica may be used.