Manual

77
Leica ASP6025
Supervisors may perform all operator functions, and additionally create programs and
perform the instrument setup functions.
"Supervisor" symbol

For supervisor mode, there are two dierent settings: "Enabled" or "Disabled"
The supervisor mode
Access levels (continued)
Supervisor access level

In order to enable supervisor mode, proceed as follows:
• IntheSecurityeld,pressSUPERVISOR MODE.
• Thekeyboardappears;useittoenterthecorrespondingpasswordandconrm
with OK.
• TheSUPERVISOR symbol is displayed in the top right corner of the screen.
• Inallmenus,theSERVICE button is replaced by the OPERATOR button.
If the Lock mode has been activated, the instrument cannot be used. Lock mode is
disabled again by entering a password.
In order to enable lock mode, proceed as follows:
• IntheSecurityeld,pressLOCK MODE.
• Thekeyboardappears,useittochooseapasswordandconrmwithOK.
• TheLOCK button is displayed on the right in all the menus. If this button is touched,
the instrument is locked and the LOCK button is replaced with the UNLOCK button.
• PressUNLOCK and use the keyboard to enter the password to unlock the
instrument.

Fig. 101
The lock mode

Fig. 102
5. Operation
Supervisor mode is disabled in factory condition. Operator and
Supervisor are distinguished by the fact that a password must be
entered to activate Supervisor mode. When a password has been
assigned, Operator mode will be activated when the instrument
is started.
If Lock mode is activated while a program is running, the program
will continue but an operator cannot intervene.