Manual

66
Instructions for Use V 2.2 RevI – 08/2013
5. Operation
The INSTALLATION menu (continued)
Upgrading software
Installing help
Fig. 76

In order to be able to install the help le, the associated le must
be present as a ZIP le on a USB stick.
•
Plug in the USB stick and press the INSTALL HELP button.
• Then,followtheinstructionsonthescreenandconrm
them as necessary. The system will automatically unpack
and install the les.
Fig. 77

There are two possible ways to update the software:
1. Using the Remote Care function:
In this case, a message appears indicating that a software
update is available.
• Conrmthisandfollowtheinstructionsonthescreen.
Calibrating the touchscreen (Fig. 78)
Fig. 78

2. The software update is delivered on a USB stick:
• ConnecttheUSBstickandpresstheUPGRADE SOFTWARE button (Fig. 77).
• Then,followtheinstructionsonthescreenandconrmthemasnecessary.
This function is a guided calibration in which various items must be pressed on the screen.
To call up the screen for this, press the CALIBRATE TOUCHSCREEN button (top gure).
• Touchtheredcircleinthemiddleofthescreen(threetimesintotal),startingintheupper-
left corner (Fig. 78, top).
• Thentouchanypointonthescreenandcheckthatthecursorfollowsthemovement
(Fig 78, bottom).
• Ifthecursormovestothepositionyouhavetouched,endcalibrationbytouchingthegreen
check mark. Otherwise, return to the rst step of the calibration process and repeat the
procedure.
