Manual

Leica ASP6025

2. Safety

Warnings – Markings on the instrument itself

Transport and Installation

• Once unpacked, the instrument may be transported only in an upright position. Follow the unpacking

instructions carefully to avoid damage to the instrument!

• Beforeeachtransport,thedrawermustbesecured(e.g.usingadhesivetape)sothatitcannotopenbyitself.

• Onlyconnecttheinstrumenttoagroundedpowersocket.Donotinterferewiththegroundingfunctionby

using an extension cord without a ground wire.

Make sure to observe the voltage settings!

The set voltage CANNOT be changed by the user.

Severe damage may occur if the instrument is connected to a power supply voltage other than that to which

it was originally set.

• Theinstallationlocationmustbewellventilated,andmustcontainnosourcesofignitionofanykind.Thechem-

icals used in the Leica ASP6025 are easily inammable and hazardous to health.

• Donotoperatetheinstrumentinroomswithexplosionhazard.

• Condensationwatermayformintheinstrumentifthereisanextremedierenceintemperaturebetween

the warehouse and the installation site and if air humidity is high at the same time. If this is the case, wait

at least two hours before switching on the instrument. Failure to comply with this may cause damage to the

instrument.

• Aftertheinstrumenthasbeenputintoservice,a SMART cleaningmustbecarried out beforeeachsubse-

quent transport – otherwise, the interior of the instrument can be severely damaged (see Chapter 6.1.4).

Markings on the instrument showing the warning triangle indicate that the correct operating instructions

(as dened in these Instructions for Use) must be followed when operating or replacing the item marked. Fail-

ure to adhere to these instructions may lead to accidents causing personal injury and/or damage to the instru-

ment or accessories or destroyed, unusable specimens.

Some instrument surfaces become hot during operation. They are marked with this warning label.

Touching these surfaces may cause burns.