User guide

Instructions for Use V 1.4, RevE – 03/2013

4.7 Switching the instrument on

4. Initial Operation

• Afterbeingswitchedon,theinstrumentwilltake

a few minutes to initialize. See opposite for cor-

responding touchscreen display (Fig. 14).

• Iftheretortisnotlocked,asignaltonesoundsfor

approx. 10 sec. during initialization of the instrument.

It is not possible to lock the retort during this time.

• Ifthe retort islocked,no signal tone sounds.

A signal tone sounds for approx. 10 seconds (wait-

ing time) when attempting to open the retort. The

retort cannot be opened during this time.

• Afterthat,theFAVORITES screen will be displayed

(Fig. 15).

Screen saver

• Ascreensaverwillturnoffthescreendisplayifno

key has been pressed for a (user-programmable)

time. Press any part of the touchscreen to restore

the screen.

After having been restored, the on-screen func-

tions will be nonoperational for a few seconds to

avoid accidental activation of any keys.

Fig. 15

Fig. 14

The instrument MUST be connected to a grounded power socket.

For additional electrical fuse protection, we recommend connecting the Leica ASP200 S to a

socket with a residual current circuit breaker.

• Connect the power cable to the power socket. If applicable, switch on the switch for

the power socket.

• To switch on the instrument, press in the ON/OFF switch on the rear panel of the

instrument (Fig. 4, 42) (ON).

• Switch on the ON/STOP switch on the right of the instrument (ON).

The ON/OFF switch and the side ON/STOP switch should remain switched on at all times to

keep the heater running for the wax baths.

The ON/STOP switch can be used in emergencies to stop the instrument during while a proce-

dure is in progress.