Installation Manual

3. INITIAL SETUP
Before going through initial setup, please make certain that the thermostat
is properly mounted to the wall. When the thermostat is initially powered
up the factory defaults are set to disable any calls for heat, cool, or fan
speeds to protect any HVAC equipment.
Settings for HVAC equipment type is done via the Enseo’s Maestro
Installation tools. Documentation for those tools are available from Enseo
and are outside the scope of this installation document.
3.1. Settings Configurations From The Thermostat UI
3.1.1. Changing Room Temperature
From the user interface select the Arrow up or Arrow down button to adjust
the temperature
3.1.2. Change Thermostat Modes
Thermostat modes can be adjusted by pressing the Mode button in the
upper right.
3.1.3. Change Fahrenheit / Celsius
The unit of measure can be changed by pressing the F/C button on the
mid left portion of the user interface.
3.1.4. Change Fan
Fan speed can be changed by pressing fan icon on the lower left. Speeds
can be change set to function automatically (Auto) or Low (1), Medium (2)
or High (3)
3.1.5. Change Set-point Heat
Set-point heat is set by pressing the mode button until the indicator above
the temperature readout says Heat. Using the Up and down arrows modify
the set-point as desired.
3.1.6. Change Set-point Cool
Set-point Cool is set by pressing the mode button until the indicator above
the temperature readout says cool. Using the Up and down arrows modify
the set-point as desired.
3.1.7. Change Backlight Control
Please reference Maestro user instructions for changes to backlight
settings.
3.2. Advanced Settings
3.2.1. Wi-Fi Settings
Out of the box the thermostat will default in its AP mode waiting to be
configured by the Enseo Maestro provisioning tool. The Maestro tool will
scan the installation QR code on the thermostat.
3.2.2. Zigbee Settings
Zigbee settings are controlled via the Enseo Maestro provisioning tool.
Please reference the Enseo Maestro APP for more details.
3.2.3. LED Display Brightness
Ambient light settings are controlled via the Enseo Maestro provisioning
tool. Please reference the Enseo Maestro APP for more details.
3.3. Factory Reset
Press and hold the reset button in hole in the
upper left of the Thermostat while it is powered
up. Once depressed the thermostat will reset.
Factory Reset
Using a paper clip or other
suitable device depress for
30 seconds and release
AP Announce
Using a paper clip or other
suitable device depress for
2 seconds and release