Instruction Manual

1. Pairing the Smart Fan
■ Turn ON the wall switch for the fan. The light on the fan will be ON.
■ Have paired and working Remote control. If the remote is not paired with the fan, press and hold OFF button
until the light on the fan blinks once within 10 seconds.
■ To pair the fan with your HPM Connect App, press and hold ‘BT’ button on the remote (up to 20 seconds) until
the light on the fan blinks 3 times.
AUTO SCAN
i) Make sure that your smart device is connected to the internet and Bluetooth & Location are turned ON.
ii) Reset the device, hold the “BT” button on the remote control until the light blinks. If the light does not blink
repeat the process.
iii) Select Add Device or “ ”
iv) Select Ventilation and select Auto Scan.
v) Select Done once added.
+
SECTION D: INSTRUCTIONS ON USING THE HPM CONNECT APP FOR SMART FAN
12
Click Next
Add Device
Ventilation
Done
Next