Instruction Manual

SECTION B: INSTRUCTIONS ON USING THE HPM CONNECT APP FOR SMART DOWNLIGHT
6
AUTO SCAN
i) Make sure that your smart device is connected to the internet and Bluetooth & Location are turned ON.
ii) Reset the device, first power ON the Downlight then switch OFF/ON 5 times (OFF period should be1-2 seconds).
Then the downlight should start blinking (slowly like breathing 3 times). If the light does not blink and stays ON,
repeat the process.
iii) Click on Add Device or “ ”
iv) Select Lighting and select Auto Scan.
v) Select Next.
+
1. Pairing the Downlight
You may pair up to a max. number of 128 downlights on a single mesh.
Click Done
Click Done
vi) Press Done once detected.
Add Device
Next
Lighting
Done