User Manual

Page 3

(800)-321-2343 www.onqlegrand.com

ON/OFF: The switch for the power.

LAN: One LAN 10/100Mbps RJ45 port connects to a network device, such as a switch or a router.

RESET: The Reset button is used to restore the AP’s factory default settings. There are two ways to

reset the Access Point’s factory defaults:

 Method one: With the AP powered on, use a pin to press and hold the Reset button (about 5

seconds) until the System LED becomes quick-flash from slow-flash. And then release the button

and wait the AP to reboot to its factory default settings.

 Method two: Restore the default settings from “System Tools > Factory Defaults” of the AP's

Web-based management page.

Wireless antenna: The external antenna is used to transmit and receive wireless data.



Note: Ensure the AP is powered on before pressing the reset button.