User Manual

Page 54
301 Fulling Mill Road, Suite G ©Copyright 2012 by Legrand,
Middletown, PA 17057 Inc All Rights Reserved.
(800)-321-2343 www.onqlegrand.com
 Enable AP Isolation - Isolates all connected wireless stations so that wireless stations
cannot access each other through WLAN. This function will be disabled if WDS/Bridge is
enabled.
4.7.5 Antenna Alignment
Selecting Wireless > Antenna Alignment will show how the remote AP's signal strength
changes while changing the antenna's direction as shown in Figure 4-23.
Figure 4-23 Antenna Alignment
 Remote RSSI - Remote AP's signal strength value.
 Signal Percent - The ratio of RSSI to RSSI RANGE in percentage.
 RSSI Range - Drag the Slider to set or input the RSSI RANGE value.