User's Manual

Owner’s Manual of DA1104
-45-
AP+WDS in the Mode of Wireless Basic Settings before you enable
WDS on this page.
MAC Address You can enter the MAC address of the AP you want to connect with.
Data Rate Default is “Auto”.
Comment You can make some comment for each MAC address on the list.
Set Security Click the “Set Security” button to configure the wireless security
parameters of the AP you want to connect via WDS.
Show Statics Click the “Show Statics” button to show the WDS AP.
Current WDS AP List You can select some MAC addresses of the AP and click the “Delete
Selected” button to delete it.
The WDS feature can only be implemented between 2 wireless devices that both support the WDS
feature. Plus, channel, security settings and security key must be the same on both such
devices. Maximum 8 remote peers are supported.
To encrypt your wireless network, click “Set Security”. For the detail of wireless security, see
section 4.3.4. Remember to reboot the device after you save your wireless security settings;
otherwise, the WDS feature may not function.
4.3.7 Site Survey
Choose menu “WLAN1 (5GHz)
 Site Survey” to scan the available local AP. If any Access Point is found, you
could choose any one to connect with manually when the Client Mode is enabled.
Figure 4-38 Site Survey – 5GHz